Filter
Top Products
109
Installing A Battery
Battery changing should only be
done by an adult.
The Parents Unit can be operated
on battery power.
1. Push a key, screwdriver, or other
object at an angle into the side slot
under the AC adapter jack as shown,
and lift up to open the battery
compartment.
2. Snap a nine volt battery into
proper terminals. An alkaline battery
is recommended. Place battery into
compartment.
3. Snap battery compartment cover
closed.
BATTERY USE TIPS
Remove battery from Parents Unit if
it will not be used for a long time.
Remove a dead battery promptly. A
dead battery left in unit may leak,
damaging your unit.
Do not attempt to recharge a non-
rechargeable battery.
A rechargeable battery CANNOT be
recharged by plugging AC adapter
into the Parents Unit. Remove the
battery from unit to recharge it.
Charging of a rechargeable battery
should only be done by an adult.
Battery power will be conserved
when Parents Unit is powered
through AC adapter. It is not
necessary to remove battery when
using AC adapter.
Change battery if:
!!
Signal reception becomes poor
!!
Static noise develops (also check
!
!!
for appliance interference)
Using AC Adapters
The Parents Unit can use either a
battery or standard 120 volt AC
household current. The Nursery
Unit uses standard 120 volt AC
household current only. The included
AC adapters must be used for this
purpose.
To use AC adapters, plug the connec-
tor on the cord into the AC adapter
jack on the side of the unit. Then
plug adapter into a standard wall
outlet.
11 12
Use ONLY the Graco
®
adapters
included with the unit. Do not use
these adapters with other equipment
under any circumstances.
If units do not work, check that AC
adapters are plugged into working
outlets.
When electricity is off (from a power
failure, etc.), the transmitter will NOT
work, since it only operates on AC
current.
901-5-98
Push in
at angle
and lift