Filter
Top Products
Caller ID Scheme
The GXW410x supports 5 different types of schemes:
1. Bellcore (US standard)
2. ETSI-FSK during ringing
3. ETSI-FSK prior to ringing with DTAS
4. ETSI-FSK prior to ringing with LR
5. ETSI-FSK prior to ringing with PR
6. ETSI-DTMF during ringing
7. ETSI-DTMF prior to ringing with DTAS
8. ETSI-DTMF prior to ringing with PR
9. ETSI-DTMF prior to ringing with PR
10. SIN 227 - BT
11. NTT (Japanese standard)
Please check with your PSTN service provider (or traditional PBX specs) for which caller ID
scheme they/it support. If you are not sure about which to use please refer to Table 10 (FXO
Lines Test Tab Definition). This tool will run an automated test to determine the proper Caller ID
Scheme so the gateway can properly detect the Caller ID.
Similarly to the cases explained above we can specify a caller ID scheme for each channel
independently.
Caller ID Transport
type
Default is “relay via From header”. You may also select :
“relay via P_Asserted_Identity header”
“Disable” : Caller ID feature will be disabled.
“Send anonymous” : All calls forwarded to VOIP end will be sent as anonymous.
T.38 Setting
This setting allows you to make several options related to facsimile.
You can select the method: T.38 or Pass through (G711)
You can select the fax transmission rates (2400/4800/7200/9600/12000/14400bps)
You can enable or disable ECM (Error Checking Mode)