Filter
Top Products
YELLOW
BLUE
GRAY
CONTROL
*NEUTRAL
*NEUTRAL
BLACK
LINE
BOTTOM
(OFF)
(ON)
TOP
(FOR RED INDICATOR)
(FOR BLUE INDICATOR)
INDICATOR
LED
HAI Auxiliary Switch Overview
The 37A00-1 HAI Auxiliary Switch (Figure 2) is an optional companion device used with the HAI UPB™ Wall Switch for multi-way
circuits. The HAI Auxiliary Switch has a Decora-style rocker switch that controls the load in the exact same manner as the Decora-
style rocker switch on the HAI UPB™ Wall Switch.
Figure 2 – HAI Auxiliary Switch
Changing Switch Color
The color of the HAI UPB™ Wall Switch and Auxiliary Switch may be changed to
complement the interior décor. The HAI UPB™ Wall Switch and Auxiliary Switch
is supplied with a white switch plate. Additional colors are available; contact your
HAI distributor for more information. When changing the switch plate, make sure
that the switch is disconnected from all power, and proceed as follows:
1. The switch plate attaches to the HAI UPB™ Wall Switch and Auxiliary Switch
with two latches on the right and two on the left. Using a small-bladed
screwdriver, gently depress the upper and lower latch on one side while lifting
up on the plate. Once the latches are released on one side, remove the switch
plate from the other side.
2. Align the latches of the new switch plate to the openings on the mounting plate
and gently snap into place.
INSTALLATION INSTRUCTIONS
The HAI UPB™ Wall Switch is wired directly to the load and can be controlled by adding one or more optional HAI Auxiliary
Switches producing multi-way circuits. Multi-way circuits make it possible for a group of switches to control the same load. This
section will illustrate how to make the connections.
Notes:
1. Refer to Figures 1 and Figure 2 to determine the wire colors for each connection.
2. All HAI UPB™ Wall Switches require a neutral (white) connection.
3. The Line (black) wire must be accessible for the installation of all HAI Auxiliary Switches. This wire may be connected to either
phase of the 120/240V supply. The blue and/or gray wire on the HAI Auxiliary Switch can be connected to either earth ground or
neutral. The blue and/or gray wire is only used to light the LED on the switch. This LED only indicates that power is applied and
serves as a night-light. Connect the blue wire only to light the LED blue. Connect the gray wire only to light the LED red.
Connect both the blue wire and the gray wire to light the LED magenta.
Figure 3 – Changing Switch Color