Filter
Top Products
Cordless Scanning System Quick Start 5
IMAGETEAM 3875
You may automatically discharge the IT3875 charge pack by scanning the
following bar code. The scanner remains operational during the discharge;
however the status LED flashes like a “heartbeat.”
Associating the Cordless Scanner to a Base
Important: Make sure the cordless scanner’s charge pack has been fully
charged. See page 3 for charging instructions.
Using the cordless scanner, scan the Association Bar Code (the bar code label
on the top of the base) to link that scanner to the base.
Two quick beeps followed by clicking, then a single beep indicates a “good”
association. The scanner is in communication with the base. If the scanner
clicks for 30 seconds and signals an error (triple beep), it has not associated with
the base.
Note:
If the charge pack is removed from the scanner and replaced after
association, the scanner automatically reassociates to the base if the
base has power. In this case, the scanner beeps when a charged charge
pack is installed, then beeps a second time after full association, typically
five to ten seconds later.
Note:
A scanner always defaults to work group 0 after scanning a base I.D. bar
code.
Sample codes have been included in the back of this Quick Start Guide. Scan a
bar code to make sure that your scanner is working correctly after you have
charged the charge pack and associated the scanner with a base.
IT3875 Charge Pack Discharge