Filter
Top Products
3–6
SCANTEAM 5700 User’s Guide
Keyboard Style
This programming selection allows you to program the scanner to support
special keyboard features, such as CAPS LOCK, SHIFT LOCK, Data Entry, and
CTRL+ codes. These special keyboard features are shown in the chart below.
Default = Style A.
Style A
[ ASCII function codes (00–1F) are sent to the terminal via a “CTRL+” sequence
(i.e., ‘CR’=CTRL+M)
(If terminal is not listed, then no secondary type keyboard is supported.)
Style B Style C Style D
IBM PC/XT XT CAPS LOCK
Keyboard Style
Terminal
SHIFT LOCK
Style E
Gr DOS SHIFT LOCK
IBM PC/AT AT CAPS LOCK SHIFT LOCK
“CTRL” + ASCII [
Gr DOS SHIFT LOCK
IBM PS2 (50–80) NORM CAPS LOCK SHIFT LOCK Gr DOS SHIFT LOCK
HDS 2000, 3200 T/W “CTRL +”
IBM 3180 (122 Key) T/W D/E
COMTERM 6178 T/W D/E
TELEX (88 Key) T/W D/E
SIEMENS 9758 NORM CAPS LOCK
NCR 7052 34Key 56 Key
122 Key Caps On 122 Key Caps Off
“CTRL” + ASCII [
“CTRL” + ASCII [
DEC Norm “CTRL +”
MAKE / BREAK
Style B
Style C
✱ Style A
Style D
Style E
Note: The Keyboard Style Table below applies the SCANTEAM 5700 software
prior to software revision level 2.0.
Keyboard Style Selections