Hasbro 69239 Robotics User Manual


 
Thank you for purchasing the
SPIDER-MAN ELECTRONIC WEB SPINNING BLASTER.
Please read and retain these instructions.
To avoid injury use only
clean tap water. Do not aim at eyes or face.
CAUTION:
Pressurized container.
Read all instructions before use.
WARNING:
ELECTRONIC WEB SPINNING BLASTER
Includes:
One 5 oz. (142 grams) can of triple stream Web Fluid
• Adjustable blaster holder
• Water tank
Shake well before using.
Can should be used in a horizontal position.
Adult Supervision Required.
Non-Toxic.
Non-Flammable.
Not Recommended for Indoor Use.
Ingredients: Water HFC 134a (propellant), Acrylic Resin, Hydrocarbon solvents, Light oil, Pigment.
Do Not Puncture Or Incinerate.
Do Not Expose to Heat or Store at Temperatures above 120° Degrees F / 48 Degrees C.
Do Not Spray on Open Flame or Any Hot Stoves or Light Bulbs.
Do Not Leave in Direct Sunlight or Store in a Hot Vehicle.
Heat Can Cause Can to Burst Violently.
Do Not Spray in Eyes or Face.
Do Not Ingest String.
WARNING:
Contents Under Pressure.
Spider-Man and all related characters and the distinctive likeness thereof:
TM & © 2007 Marvel Characters, Inc.
Spider-Man 3, the Movie: TM & © 2007 Columbia Pictures Industries,
Inc. All rights reserved.
®* and/or TM* & © 2006 Hasbro. All Rights Reserved.
TM & ® denote U.S. Trademarks.
P/N: 6652490000
*
Not suitable for children
under 3 years because of
small parts — choking hazard.
®
AGES
5+
69239
x3
BATTERIES
ALKALINE
REQUIRED
1.5VAA/LR6 size
Phillips/cross head screwdriver (not included)
needed to insert batteries.
NOT INCLUDED
Do not spray on walls, fl oors,
CAUTION:
clothing, furniture or vinyl as string may stain certain types
of surfaces and fabrics. USE ONLY AS DIRECTED.
Lift locking ring.
3
Snap rear ring on
Water Tank into
Holding Clip.
4
Push in Rear Clamp and
push Lock Button.
5
Close and lock locking ring. Blaster will
not spin if locking ring is disengaged.
6
Pump handle 15-20 times.
Press trigger with middle
fi ngers to shoot water.
7 8
Water Blaster Assembly & Use:
Unscrew cap and fi ll tank with clean water to
about the half or three-quarters level. Replace cap.
Always remove from Blaster Holder when fi lling.
1
Push Lock Button in and
pull out Rear Clamp.
2
5008(SPD_69239_Spinning_Blaster.indd)2006-11-0508/Eva/2006-11-18/CN_Mac7/BR/Artech_150L
185 K