Filter
Top Products
GS108T Smart Switch Hardware Installation Guide
Physical Description 2-3
v1.0, March 2007
Reset Button
The Reset button of the GS108T triggers a hardware reset of the switch. Figure 2-3 shows its
location on the front panel. This action is equivalent to switching the unit power off and back on.
The last saved configuration is loaded into the switch as it resets. To operate the reset button, insert
a device such as a paper clip into the opening to press the recessed button. The front-panel LEDs
should extinguish and light again as the switch performs its Power On Self Test (POST).
10Mbps Link / ACT LED
(Right LED)
n/a Off No 10Mbps link is established on the
port
Green On - Solid A valid 10Mbps link is established on
the port
Green On - Blinking Packets transmission or reception is
occurring on the port, linked at 10Mbps
mode
1000Mbps Link / ACT LED
(Both LEDs)
n/a Off No 1000Mbps link is established on the
port
Green On - Solid A valid 1000Mbps link is established on
the port
Green On - Blinking Packets transmission or reception is
occurring on the port, linked at
1000Mbps mode
Table 2-1. Front Panel LEDs (continued)