Filter
Top Products
Model HEC-103/104/123/124
3-3 705
3-3. START UP
Before using the heated express cabinet, thoroughly clean the unit
as described in the Cleaning Procedures Section of this manual.
1. Turn the power switch to the ON position.
2. If the heat values for the shelves have not been set, pull out on one
corner of the bottom front panel, and unsnap it from the unit, to
access the controls.
3. Press and hold and use to set the heat value of the
base (or bottom) shelf. It can be set from “OFF” to a maximum
of “10”.
The upper heat settings read 1, 2, 3, etc. 1 meaning the heat is on
10% of the time, 10 meaning the heat is on 100% of the time.
If “LOC” shows on the display when trying to set the heat value,
this means the controls are locked and the settings cannot be
changed until unlocked in the Special Program Mode.
4. Press and hold each shelf button and use to set the heat
value to each corresponding shelf.
These can be set from “OFF” to a maximum of “10”. Use the
diagram below the buttons to find which button controls which
shelf. Ex: Press and hold to set the bottom shelf heat
value.
A heat value setting of 8 for the base and all shelves is recom-
mended to hold prepackaged whole chickens .
5. Once controls are set, replace front panel by lining up the clips
and firmly snapping them into place.
6. Allow unit to preheat for about 30 minutes.
7. Prepackaged food products can now be placed on each shelf.
All shelf surfaces are hot! Burns could result!