HP (Hewlett-Packard) 1103 Laptop User Manual


 
WWAN and GPS modules (select models only)
NOTE: The WWAN module and the GPS module are very similar. Either can populate the WWAN
slot.
Description Spare part number
HP lc 2010 Mobile Broadband Module (HP Mini 110/Compaq Mini CQ10 models only) 612600-001
HP lc 2000 Mobile Broadband Module (HP Mini 110/Compaq Mini CQ10 models only) 612599-001
Qualcomm Gobi 2000 3G WWAN module (select models only) 531993-001
HP hs2320 HSPA Mobile Broadband Module (HP Mini 1103 models only) 574248-001
CAUTION: The WWAN module and the WLAN module are not interchangeable.
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless
module authorized for use in the computer by the governmental agency that regulates wireless
devices in your country or region. If you replace the module and then receive a warning message,
remove the module to restore device functionality, and then contact technical support.
Before removing the WWAN or GPS module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 35).
b. Service access cover (see
Service access cover on page 38).
Remove the WWAN or GPS module:
1. Disconnect the antenna cable or cables (1) from the WWAN or GPS module.
NOTE: The antenna cable with the red label is connected to the WWAN module “Main”
terminal. The antenna cable with the blue label is connected to the WWAN or GPS module “Aux”
terminal.
NOTE: The GPS module does not use the Main cable, therefore the Main cable is not
connected. When you work with the GPS module, it is important to keep the plastic tubing that
covers the Main cable in place.
2. Remove the 2 Phillips 2.0×3.0 screws (2) that secure the WWAN or GPS module to the system
board. (The module tilts up.)
Component replacement procedures
43