![](http://pdfasset.owneriq.net/c/d7/cd7fec4f-80c0-4bc4-9c1e-0a1848b1c33f/cd7fec4f-80c0-4bc4-9c1e-0a1848b1c33f-bg7.png)
2 Installing the 3COM EtherLink III 3C509B ISA 10BT Network Adapter
Microsoft Windows 95 SR2.5
2 Installing the 3COM EtherLink III 3C509B ISA 10BT
Network Adapter
Microsoft Windows 95
SR2.5
Connecting to a
Windows NT 4.0 Server
Requirements
• HP Vectra with Windows 95 SR2.5.
• 3COM EtherLink III 3C509B-TP ISA 10BT network adapter and drivers
disk version 6.0.
• Driver File: ELNK3ND3.SYS, version 5.26.31
• Microsoft Windows 95 SR2.5 media.
• Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink
IPX/SPX Compatible Transport and NWLink NetBIOS network protocols.
• Device Configuration
Procedure
1 Power on the system and start Windows 95SR2.5.
2 From the 3COM 3C509B driver disk, run PREINSTL.EXE.
3 Shutdown and power down the system. With the HP Vectra turned off,
install the 3COM 3C509B network adapter into an ISA slot.
4 Connect network cable media to the 3COM 3C509B network adapter.
5 Power on the system and press “SHIFT-<F5>” to boot to Windows 95
command prompt.
6 Insert the 3COM 3C509B driver disk and execute “3C5X9CFG.EXE”.
7 Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration”.
8 If changes are required, save those changes and exit.
9 Remove the 3COM 3C509B driver disk and reboot the system to Windows
95SR2.5.
Device Configuration Vectra Vli8 Vectra VEi7 Vectra VEi8
Interrupt 05 03 07
I/O Address 210 210 210