Filter
Top Products
Operating Temperature
(System Inlet Air
Temperature)
50° to 95° F (10° to 35° C)
SAS Quick Release LFF (3.5-inch) Midline (MDL) Drives
Application
SAS Midline drives are intended for servers and storage solutions where high capacities are required.
These drives have moderately-priced reliability and performance for non-mission critical, low workload
applications, such as disk backup, archival, and reference applications.
Transfer rate
The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server
backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated
down to an acceptable level for all components.
HP 4TB 6G SAS 7.2k rpm
LFF (3.5-inch) Quick-
release Dual Port MDL 1y
Warranty Hard Drive
697956-B21
Capacity
4,000,787MB
Height
1.165 in (29.6 mm)
Width
4.157 in (105.6 mm)
Depth
5.787 in (147.0 mm)
Interface
SAS
Transfer Rate
Synchronous
(Maximum)
6Gb/sec
Seek Time
(typical reads, including
settling)
Single Track
0.7 ms
Average
8.5 ms
Full-Stroke
15.7 ms
Rotational Speed
7,200 rpm
Physical Configuration
Bytes/Sector
512
Logical Blocks
7,814,037,168
Operating Temperature
(System Inlet Air
Temperature)
50° to 95° F (10° to 35° C)
NOTE:
To support HP hard drives exceeding 2.2 TB, HP Smart Array Firmware
version 5.0 or later is required for the following controllers:
HP Smart Array P212 Controller
HP Smart Array P410 Controller
HP Smart Array P411 Controller
HP Smart Array P711m Controller
HP Smart Array P812 Controller
To use hard drives exceeding 2.2 TB, you must create a boot volume using
offline ACU version 8.75 or later. HP Smart Array controllers do not support
boot volumes exceeding 2.2 TB. Other controllers are not supported
HP 2TB 6G SAS 7.2K rpm
574761-B21
Capacity
2,000,398,934,016
QuickSpecs
HP SAS Hard Drives
Technical Specifications
DA - 12244 Worldwide — Version 44 — December 9, 2013
Page 32