HP (Hewlett-Packard) 5590 Scanner User Manual


 
7
how to scan from the automatic
document feeder
This section explains how to use the automatic document feeder (ADF) for the
HP Scanjet 5590 scanner.
choose acceptable media for the ADF
The ADF works best when the originals meet the following specifications. If the
originals do not meet these criteria, scan from the scanner glass.
For one-sided scanning, you can use legal-size paper: 210 mm by
355.6 mm (8.5 by 14 inches).
For two-sided scanning, use A4-size or letter-size media. The ADF cannot
scan both sides of a document smaller than 127 mm by 127 mm (5 by
5 inches) or larger than 210 mm by 304.8 mm (8.5 by 12 inches).
Custom-size media ranging from 88.9 mm by 127 mm (3.5 by 5 inches)
to 216 mm by 356 mm (8.5 by 14 inches) can be scanned with the one-
sided option.
Tip: To scan both sides of a legal-size document, 216 mm by
356 mm (8.5 by 14 inches), scan one side in the ADF, turn the
document over, and then scan the other side in the ADF.
Media weights from 60 to 90 grams per square meter (g/m
2
) (16 to
24 lbs).
Media that does not contain perforations or punch holes.
Media that does not contain wet glue, correction fluid, or ink.
Note: Avoid putting multipart forms, transparencies, magazine pages,
gum-backed pages, and lightweight paper in the ADF.
Before placing an original in the ADF, check for and remove curls, wrinkles,
staples, paperclips, and any other attached material.
load originals in the ADF
1 Place a stack of similarly sized documents face-up in the document input
tray, with the first page on top.
Load a document and center it in the ADF tray
2 Adjust the paper guides to center the stack.
3 Press a scanner button or use the HP Director to begin scanning. Follow
the instructions on the computer screen to finish scanning.
2