Filter
Top Products
Operations 25
To remove the component:
1. Power down the server (on page 23).
2. Extend the server from the rack (on page 23).
3. Open or unlock the locking latch, slide the access panel to the rear of the chassis, and remove the
access panel.
Install the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the
rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the hood latch. The access panel slides to a closed position.
3. Tighten the security screw on the hood latch.
Access the product rear panel
Opening the cable management arm
To access the server rear panel:
1. Release the cable management arm.