Filter
Top Products
Weight & Dimensions
(MT)
Chassis Dimensions
(H x W x D)
15.14 x 7.27 x 16.36 in
385 x 185 x 416 mm
Packaged Dimensions
(L x W x H)
19.13 x 21.875 x 10.13 in
490 x 556 x 257 mm
System Weight
22.4 lb (10.2 kg)
Shipping Weight
30.8 lb (14.0 kg)
Weight & Dimensions
(SFF)
Chassis Dimensions
(H x W x D)
3.98 x 13.35 x 15.24 in
101 x 339 x 387 mm
Packaged Dimensions
(L x W x H)
23.38 x 19.68 x 9.0 in
593.8 x 500.0 x 228.6 mm
System Weight
14.96 lb (6.79 kg)
Shipping Weight
23.00 lb (10.43 kg)
Technology and
Features
Memory Type
PC2-6400 DDR2 SDRAM (800MHz) non-ECC
Up to 16 GB system memory standard
NOTE:
For systems configured with more than 3 GB of memory and a 32-bit operating system,
all memory may not be available due to system resource requirements. Addressing memory
above 4 GB requires a 64-bit operating system.
Hard Drive Interfaces
Supported
Serial ATA
RAID
Redundant Array of Independent Drives
RAID 0,1 are the RAID configurations that HP Compaq dx7500 Business PC products offer as
factory configurations. The pre-configured systems:
Are only available on the MT form factor. The SFF does not support RAID, as it does not
allow for more than one hard disk drive.
Are complete RAID systems and have both drives installed.
Have the necessary Option ROM configuration.
Are pre-loaded and pre-installed with all required Intel software.
Include a preinstalled operating system that is in mirrored mode out of the box.
SMART Technology
*
(Self-Monitoring,
Analysis and Reporting
Technology)
Allows hard drives to monitor their own health and to raise flags if imminent failures were
predicted
Predicts failures before they occur. Tracks fault prediction and failure indication parameters
such as re-allocated sector count, spin retry count, calibration retry count
By avoiding actual hard drive failures, SMART hard drives act as "insurance" against
unplanned user downtime and potential data loss from hard drive failure
IOEDC: I/O Error Detection Circuitry
Detects errors in Read/Write buffers on HDD cache RAM
Interface in F10 setup provides confirmation of SMART support.
* This feature is inoperable when a RAID configuration is enabled.
QuickSpecs
HP Compaq dx7500 Business PC
System Details
DA - 13152 Worldwide QuickSpecs — Version 6 — 2.24.2009
Page 7