Filter
Top Products
Solid-state drive
NOTE: This section applies only to computer models equipped with an Intel processor.
Description Spare part number
24-GB solid-state drive 720564-001
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 43).
Remove the solid-state drive:
1. Loosen the Phillips PM2.0×4.0 captive screw (1) that secures the service cover to the computer.
2. Lift the rear edge of the service cover (2) and swing it up and forward until it disengages from
the computer.
3.
Remove the service cover (3).
The service cover is available using spare part number 720555-001.
4.
Remove the two Phillips PM2.0×2.5 screws (1) that secure the solid-state drive to the system
board. (The solid-state drive tilts up.)
44 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts