Filter
Top Products
Base enclosure
NOTE: The base enclosure spare part kit includes four rubber feet, the service cover release latch
assembly, and the battery release latch assembly.
Description Spare part number
For use only on HP EliteBook 8570p Notebook PC computer models 641182-001
For use only on HP ProBook 6570b Notebook PC computer models 644695-001
NOTE: When replacing the base enclosure, remove the modem cover from the slot in the base
enclosure of if the repaired unit includes a modem module.
Before removing the base enclosure, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 81), and then remove the following components:
a. Service cover (see
Service cover on page 83)
b. Optical drive (see
Optical drive on page 84)
c. Hard drive (see
Hard drive on page 87)
d. WWAN module (see
WWAN module on page 92)
e. WLAN module (see
WLAN module on page 94)
f.
Fan (see
Fan on page 100)
g. Keyboard (see
Keyboard on page 101)
NOTE: When replacing the base enclosure, be sure to remove the following components from
the defective base enclosure and install them on the replacement base enclosure:
●
Speaker assembly (see
Speaker assembly on page 111)
●
RJ-11 jack assembly (see
RJ-11 jack cable on page 112)
Remove the base enclosure:
1. Close the computer.
2.
Turn the computer upside down, with the front toward you.
3.
Remove the three rubber screw covers (1), (2), and (3). Note that the rubber screw covers are
three different sizes and shapes. The rubber screw covers are included in the Rubber Kits, spare
Component replacement procedures
107