Filter
Top Products
Chapter 5 61
Options and Accessories
Options
Options
Option
Number
Name Description
0B0
Manual Set on CD-ROM
Only
The documentation CD-ROM contains the standard
documentation set as well as Adobe Acrobat Reader with Search.
0B1
Additional Manual Set An additional set of the standard documentation shipped with
the analyzer. See “Initial Inspection” on page 7 for information
about the standard documentation set.
0BW
Service Documentation The Service guide describes assembly-level troubleshooting
procedures, provides a parts list, and documents post-repair
procedures.
1CM
Rack Mount Kit Includes rack mount flanges and hardware. Used to rack mount
analyzers without front handles (available as P/N 5063-9215).
1CN Front Handle Kit Available as P/N 5063-9228.
1CP
Rack Mount Kit with
Handles
Includes the parts necessary to rack mount an analyzer with
front handles attached (available as P/N 5063-9222). (Includes
handles.)
1CR
Rack Slide Kit Available as P/N E4406-60115. Rack slides allow the analyzer to
be pulled out while the analyzer is secured to the rack.
1DS
Preamplifier An internal preamplifier assembly.
Frequency Range: 100 kHz to 3 GHz
122 80 MHz Bandwidth
Digitizer
Adds an alternative 80 MHz wide IF path for making
measurements. Additional measurement accuracy can be
achieved using the External Calibration Wizard Option 235, or
with the 89600 Vector Signal Analyzer Application calibration.
The 80 MHz functionality is available as part of the added Basic
Mode. Basic Mode includs the measurements:
spectrum (frequency domain)
waveform (time domain)
123
Switchable Microwave
Preselector Bypass
Allows you to bypass the tuned filter at the input of the spectrum
analyzer when making measurements in the 3 - 26.5 GHz range.
This improves the sensitivity and increases the available
measurement dynamic range. However it allows the analyzers
internal mixing products and image response signals to be
visible on the display, in addition to the actual desired signal
response.