Filter
Top Products
Installing the Memory Module
13HP StorageWorks ESL9000 Series Tape Library Memory Module Upgrade Guide
Note: The AC power distribution assembly is located in the base of the cabinet, behind
the left tape drive access panel.
Removing the Robotics Controller
To remove the robotics controller:
1. Open the center access door on the rear of the library.
2. Remove the six Phillips screws that secure the cover over the electronics bay,
and remove the cover (see Figure 1).
Figure 1: Robotics controller and electronics bay cover
3. Locate the robotics controller at J5/J6 of the backplane.
4. If present, disconnect the RS-232 cables at connectors J2 and J3 at the left
edge of the robotics controller.
5. Remove the small Phillips screw that secures the robotics controller in the
electronics bay.
6. Remove the robotics controller from the electronics bay.
1 Robotics controller
2 Electronics bay cover