Filter
Top Products
The figure above shows how to connect an xDSL modem to a home coaxial cable network. Follow
the same steps to connect any Ethernet device such as a HUB or printer, to a coaxial cable network.
Now you should have connected the LAN port, HCNA port and the DC5V port to the appropriate
devices or lines. LED will be as:
POWER ON
LAN Link/Act ON
HCNA Link/Act ON
HCNA SyncMode ON
For more information on LEDs, see section
"LED Indicators on the Front Panel"
TROUBLESHOOTING
The bridge has been designed to be a reliable and easy to use connection device. Please refer to the
list below to aid in troubleshooting.
The Power (green) LED is off.
Make sure the power adapter is properly plugged into a live electrical outlet.
The LAN(Ethernet) or HCNA Link/Act LED is off.
Make sure the connection to these two ports is secure.
The Ethernet or HCNA device to which you are connected should be powered on and properly
configured
.
The HCNA SyncMode LED is off.
The LED should be always ON after power on.
The Ethernet or HCNA device to which you are connected should be powered on and properly
configured.