Filter
Top Products
36 Chapter 1 – Control-panel messages EN
STOP/CLEAR was pressed to cancel the current job while pages were
feeding from the document feeder. The cancel process will not
automatically clear the document feeder.
1 Pull the document-release door open, remove the jammed item, and
close the door.
2 Clear the items in the document-feeder tray and start over.
1 Close the rear output bin.
2 If the message persists, check sensor PS702 in the duplexer.
1 Check that all doors and trays are closed.
2 Check the tabs and sensor levers in the tray for proper operation.
3 Replace any defective tabs or sensors.
4 Replace the PCA controller in the feeder.
1 Ensure the optional output device is fully seated and properly
installed.
2 Make sure that the paper path is closed between the printer and the
external paper-handling output device.
Canceled scan/Clear document feeder
Cannot duplex/Close rear bin
Check input device alternates with
Paper path open, please close it
Check output device alternates with
Close output delivery path