Filter
Top Products
HP LTO Ultrium 4 drives technical reference manual, volume 5: UNIX, Linux and OpenVMS configuration guide 13
Figure 2 SAM text-based interface
For HP-UX 11i v1 (11.11)
1. Enter sam at the command line.
% sam
2. Select the following:
Kernel Configuration
Drivers
3. Highlight the stape driver. If the driver has not been added to the kernel, both Current State
and Pending State will read “Out”.
4. Select the following:
Actions
Add Driver to Kernel
The Pending State will now read “In”.
5. To add the new driver to the kernel, select:
Actions
Create a New Kernel
The stape driver is added to the kernel.
6. If you are going to attach an autoloader, use a similar procedure to change
schgr to “static”.
7. Reboot the system.
For HP-UX 11i v2 (11.23)
1. Enter sam at the command line.
% sam
2. Select the following:
Kernel Configuration
Kernel Configuration (character mode)
Modules