Filter
Top Products
Part Number
Printed in
50%
D8041-90001
Paper not bleached with chlorine
Error Messages Recommended Action
C:DRIVE ERROR Check hard disk type in Setup.
C:DRIVE FAILURE Replace hard disk.
CH-2 TIME ERROR Replace system board.
CMOS CHECKSUM ERROR
Run Setup, replace battery if error persists.
CMOS SETTINGS WRONG/CMOS DISPLAYTIME WRONG
CMOS CHECKSUM BAD
CMOS SYSTEM OPTIONS NOT SET
CMOS TIME AND DATE NOT SET Reboot, then set time and date in Setup
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER Insert system disk in
A:/ and press Enter. When booting from hard disk, check hard disk controller installation and
cables.
NON SYSTEM DISK OR DISK ERROR
DISK DRIVES OR TYPES MISMATCH ERROR - RUN SETUP CMOS Check drive type in Setup. Change jumper setting if necessary.
DISPLAY SWITCH IS SET INCORRECTLY Check video setting in Setup.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT Check video setting in Setup.
ERROR ENCOUNTERED INITIALIZING HARD DISK DRIVE/ ERROR
INITIALIZING HARD DISK CONTROLLER
Check hard disk controller installation, cables and jumper configuration. Check disk type in Setup.
HDD CONTROLLER FAILURE
FLOPPY DISK CNTRLR ERROR/ NO CNTRLR ERROR/ NO CNTRLR
PRESENT
Check FDD controller installation. If no FDD is installed, run Setup and disable floppy drive.
FDD CONTROLLER FAILURE
KEYBOARD ERROR/ NO KEYBOARD PRESENT Check keyboard is correctly connected. Make sure no keys are pressed during boot.
KB/ INTERFACE ERROR Check keyboard is correctly connected.
PS/2 MOUSE ERROR Check mouse is correctly connected.
MEMORY SIZE HAS CHANGED SINCE LAST BOOT Check memory size in Setup.
MEMORY VERIFY AT... Use specified location to locate bad memory module.
MEMORY PARITY ERROR AT...
I/O CARD PARITY ERROR AT... Use specified location to locate expansion card failure.
PRESS A KEY TO REBOOT An error has occurred, press any key to reboot.
PRESS F1 TO DISABLE NMI, F2 TO REBOOT BIOS detects NMI (Non-Maskable Interrupt). Press F2 to reboot or F1 to disable NMI.
RAM- CHECKING FOR SEGMENT... Change bad RAM module.
SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT Boot attempt aborted. Press Ctrl + Alt+ Del to reboot.
The computer beeps... You should...
1,2 or 3 times Reset memory DIMMs, replace it if necessary.
5 times Reset the processor, replace it if necessary.
6 times Change the keyboard or replace the fuse if applicable.
9 times Replace system board.
4,7,8,10 times Replace the system board or video controller.
drac-usr.bk : drac-bc.fb4 Page xxxii Friday, April 30, 1999 3:48 PM