Filter
Top Products
ftp> user root
331 User name ok, need password
Password: pass (this is not echoed)
230 User logged in
ftp> get config
local: config remote: config
200 PORT command successful.
150 Opening data connection for config (192,0,2,2),
(mode ascii).
226 Transfer complete.
##### bytes received in #.## seconds (##### Kbytes/s)
ftp> quit
221 Goodbye.
Next, edit the file with your favorite text editor and locate the lines beginning with:
RTN_OPT. : YES
RTEL_PR1. : 0
RTEL_PR2. : 0
RTEL_PR3. : 0
RTEL_PR4. : 0
RTEL_PR5. : 0
RTEL_PR6. : 0
RTEL_PR7. : 0
RTEL_PR8. : 0
Change the RTN_OPT line to read:
RTN_OPT. : NO
This disables the Reverse TELNET protocol and enables the standard TELNET protocol on the print server.
Next, assign a port number for each parallel and serial port on the server as follows:
RTEL_PR1. : 9100
RTEL_PR2. : 9101
RTEL_PR3. : 9102
RTEL_PR4. : 9103
RTEL_PR5. : 9104
RTEL_PR6. : 9105
RTEL_PR7. : 9106
RTEL_PR8. : 9107
This essentially makes the Axis print server look like a Hewlett Packard JetDirect EX print server. Save the
file and then upload the new config file using the ftp command:
ftp ip-address
Connected to ip-address.
220 Axis NPS ### FTP Printer Server V#.## MON DD YEAR ready.
ftp> user root
331 User name ok, need password
Password: pass (this is not echoed)
230 User logged in
ftp> put config CONFIG
local: config remote: CONFIG
200 PORT command successful.
150 Opening data connection for config (192,0,2,2), (mode ascii).
226 Transfer complete.
##### bytes received in #.## seconds (##### Kbytes/s)
ftp> get hardreset
local: hardreset remote: hardreset
200 PORT command successful.
421 Axis NPS ### hard reset, closing connection.
ftp> quit