Filter
Top Products
ENWW Setting the registration 75
Setting the registration
Use the Set Registration feature to center the front and back images on a page that has been
duplexed (printed on both sides). This feature also helps you set edge-to-edge printing to within
approximately 2 millimeters (0.1 inch) of all edges of the paper. Image placement will vary
slightly for each input tray. The alignment procedure must be performed for each tray. The
administrator can use an internal-tray registration page to calibrate each tray.
To set the registration
1 Press to open the menus.
2 Use and to scroll to CONFIGURE DEVICE and then press .
3 Use and to scroll to PRINT QUALITY and then press .
4 Use and to scroll to SET REGISTRATION and then press .
You can select a tray by specifying a SOURCE. The default SOURCE is tray 2. If you want to set the
registration for tray 2, go to step 7. Otherwise, proceed to the next step.
5 Use and to scroll to SOURCE and then press .
6 Use and to select a tray and then press . After selecting a tray, the control-panel
display returns to the SET REGISTRATION menu.
7 Use and to scroll to PRINT TEST PAGE and then press .
8 Follow the instructions on the printed page.