Filter
Top Products
hp psc 1300 series all-in-one
Macintosh OS 9, OS X
1 43
8
6
7
5
10
9
2
www.hp.com/support
Copyright Hewlett-Packard Company 2003
a
b
c
a
b
c
a
b
c
d
f
e
hp_all-in-one_installer
a
b
Macintosh
Macintosh OS 9, OS X
h
p
p
s
c
1
1
0
0
p
r
i
n
t
e
r
s
c
a
n
n
e
r
c
o
p
i
e
r
a
b
This side of the poster is for
Macintosh users only.
Follow the steps on this poster
in order.
Congratulations! You are now ready to use your
HP PSC. Select the HP Director icon in the dock to
get started.
If you encounter problems during setup, see the
Reference Guide.
Press the On/Resume
button to turn on the
HP PSC. Wait for it to
finish initializing.
Remove the bright pink tape from
the print cartridges. Do not touch
the gold-colored contacts or retape
the cartridges.
Hold the black print cartridge with the large HP label and the raised
markings on top. Slide the cartridge at a slight angle into the right
side of the print carriage.
Press firmly until the print cartridge snaps into place.
Close the print-carriage access door. Within a few minutes, a print
cartridge alignment page prints.
Place the top of the alignment page face down on the front left corner
of the glass. Close the lid.
Hold the color print cartridge with the large HP label and the raised
markings on top. Slide the cartridge at a slight angle into the left side of
the print carriage.
Press firmly until the print cartridge snaps into place.
Make sure that both print cartridges are secure.
Press the Scan button.
After the On light stops blinking,
alignment is complete. Discard or
recycle the alignment page.
Lower the print-carriage
access door. The print
carriage slides to the
middle.
Macintosh setup poster
Printed in Singapore or Malaysia.
Turn on your Macintosh and wait
for it to finish starting up.
Insert the Macintosh HP PSC CD.
Double-click the
HP All-In-One
Installer icon on
the desktop.
Follow the onscreen instructions.
You may have to restart your
Macintosh during setup. Be sure to
complete the setup assistant.
If you have an iMac, the USB
port is on the side. Do not
connect the HP PSC to a USB
port on a keyboard or a non-
powered USB hub. See the
Reference Guide for more
details.
Macintosh users
START HERE
Attach the front panel cover
Load plain white paper
Connect the USB cable
Connect the power cords
Turn on the HP PSC
Insert and align the print cartridges
Install the software
Try the HP PSC
Unpack the device
Remove the adhesive backing
from the front panel cover.
Raise the lid of the HP PSC.
Place the front panel cover into
the recess and stick it into place.
The HP PSC will not work until
you attach the front panel cover!
a
b
Tri-color Black