Filter
Top Products
1
4
8
5
7
1
3
1010
2
9
1111
6
a
b
c
d
Macintosh Direct Connect (USB) setup poster
Macintosh Direct Connect START HEREMacintosh Direct Connect START HERE
This side of the poster covers Macintosh direct
connect setup. See reverse side for Windows.
Network setup is covered on the other poster. Make
sure you use the correct poster and CD.
Attach front panel cover
Load paper
Connect phone cord
Turn HP device on
Insert print cartridges
Connect power cords
Install software
Align print cartridges
Congratulations!
Lift the print carriage door up
until it catches. Lift the blue
and gray latches.
Remove the bright pink tape
from both print cartridges. Do
not touch the gold-colored
contacts or retape the
cartridges.
Press OK on the front
panel to begin alignment.
After a page prints,
alignment is complete.
Discard or recycle this
page.
Make sure both latches are
locked into position. Close
the door.
Turn on your Macintosh and
wait for it to finish starting up.
Insert the HP PSC Macintosh
CD.
Double-click the HP All-
In-One Installer icon on
your desktop.
Follow the onscreen
instruction. Make sure you
complete the Setup
Assistant.
Use blank white paper
to prepare for print
alignment.
You are ready to begin
using your HP PSC. See
the Reference Guide to
get started.
Remove any packaging material.
Place the front panel cover over
the buttons. Firmly press on the
sides to snap the cover in place.
Make sure all the buttons are
visible.
Lift the display.
a b
c
a
b
c
d
e
a
b
c
a
Connect USB cable
Press down on the gray latch
until it locks into place. Insert
the color cartridge on the left
side, and lock into place.
Turn power on. Wait for the print
cartridge message to appear, and
then continue.
Do not connect the USB cable to
a keyboard.
You must connect the
supplied phone cord to the
phone jack on the left
(1-LINE).
To connect an answering
machine or use your own
phone cord, see the Fax
Setup chapter in the
Reference Guide.
b
1-LINE
hp psc 2500 photosmart series all-in-one
Hold the black print cartridge with the
label on top as shown. Slide the
cartridge underneath the metal bar
into the right (gray latch) side of the
print carriage.