Filter
Top Products
RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
22
RPC-2 Series
(c) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : On
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
Likewise, typing
ON 0
at the RPC > prompt
and responding “Y” for yes, turns “On” all
outlets. Typing
OFF n
at the RPC > prompt
turns off corresponding outlet(s).
The
REBOOT n
command will reboot or
reset equipment attached to corresponding
receptacle(s). When the command to
REBOOT (n) is sent from the RPC >
prompt, the RPC powers “Off”
corresponding outlet(s) for approximately 10
seconds, then powers them up in sequence.
This command only works on outlets which
were “On” prior to the reboot.
CONFIGURATION
The RPC-2’s configuration menu allows the
user to (1) set or change a password and (2)
customize the outlet name(s) to identify
equipment attached to the RPC. In addition
to “Change Password” and “Change Outlet
Name,” the RPC-2A’s configuration menu
allows enabling/disabling confirmation and
enabling/disabling status menu.
The password is disabled from the factory
by making the password a carriage return. If
a password (other than a carriage return) is