Filter
Top Products
C
C E N T R O N I C S I N T E R F A C E B O A R D
C - 3
V8.5e Rev 2.2.2002
Specifying XX YY at values greater than those indicated
will cause the V8.5E to terminate scans incorrectly.
3.) 1B 4X and control characters
Other commands that can be sent to the V8.5E Centronics
adapter:
1B 41 remote clear
1B 42 remote line terminate
1B 43 remote end of transmission
1B 44 remote form feed
1B 45 remote reset
1B 50 ZZ sends blank scans to plotter from ZZ = 01
hex to FF hex
NOTE: These commands must be sent when the plotter is
in print mode. The commands will be ignored and inter-
preted as raster data if they are sent at any other time.
The V8.5E plotter also obeys standard control characters
which must be sent when the plotter is in print mode:
04 end of transmission
0A line feed
0C form feed
NOTE: print mode on the V8.5E means that all bytes that are
received by the plotter are interpreted as ASCII characters and
printed at 108 characters/line.