Filter
Top Products
D-36
To select 10 Mbits/sec network speed and full duplex mode, type the
following at the prompt:
Configuration Menu: Enter command > LanConfig
10/Full_dx
To select 100 Mbits/sec network speed and half duplex mode, type
the following at the prompt:
Configuration Menu: Enter command > LanConfig
100/Half_dx
To select 100 Mbits/sec network speed and full duplex mode, type the
following at the prompt:
Configuration Menu: Enter command > LanConfig
100/Full_dx
To select the AUI port (10 Mbits/sec, half duplex only), type the fol-
lowing at the prompt:
Configuration Menu: Enter command > LanConfig AUI
NOTICE: The LAN setting defaults to LAN–TP(RJ45). If
that setting fails, the system tries the LAN–AUI
setting. Also note that the new lan configura-
tion settings take effect at the next BOot or
SEArch command.
Displaying System Information
The all command allows you to display the system’s processor revi-
sion and speed, cache size, memory size, flag settings, and the boot
and console paths. To display system information from the Informa-
tion Menu, type the following at the prompt:
Information Menu: Enter command > all
This information is paged to allow you to view it as necessary.