Filter
Top Products
H.SIZE or Horizontal Size adjustment control:
This is the monitor’s width size adjustment, you need to center the
screen horizontally first before making this adjustment. Sometimes
increasing the Horizontal size to the limits may cause the monitor to
behave abnormal or the screen may become shaky. Normally leave about 1/8 of inch of blank
border on each side of the screen, for the best result. This is needed for the proper monitor
timing adjustment.
H. Center or Horizontal Center Control:
This moves the screen to the right and left.
HEIGHT or Vertical size adjustment control:
This is your vertical height adjustment. You need to center the screen
vertically first to get this correct. In some cases the video card will show
a bigger size for 640x480 and 1280x1024 resolutions than the
1024x768. In this case if you want to be able to see most resolutions completely, adjust the
monitor for 1280x1024, so that 640x480 will fill up the screen too.
V-CENT or Vertical center adjustment control:
This control will move the screen up or down (vertical center). In some
cases the video card will show a bigger size for 640x480 and
1280x1024 resolutions than the 1024x768. In this case if you want to be
able to see most resolutions completely, adjust the monitor for 1280x1024, so that 640x480
will fill up the screen too.
SPCC (Side Pin Control) or Screen geometry balance control:
Do not touch this control, unless the screen is not straight from the
sides.
Zeon PDF Driver Trial
www.zeon.com.tw
Zeon PDF Driver Trial
www.zeon.com.tw