Hitachi CP-S317W Projector User Manual


 
16
VIDEO
ASPECT
HOME
END
MUTE
PAGE DOWN
KEYSTONEFREEZE
OFF
ON
MENUPOSITION
ENTER
ESC RESET
PAGE UP VOLUME
MAGNIFY
AUTO BLANK
RGB SEARCH
STANDBY/ON
1
Press the STANDBY/ON button (control
panel or remote control)
The message "Power off?" will appear on the screen for approximately 5 seconds.
3
Check that the POWER indicator stops
blinking and lights to solid
orange.
Switch the power switch to
[O] (OFF).
4
Confirm that the POWER indicator has
gone off and then attach the lens cap.
When the projector has completed powering down, the
POWER indicator will go off.
STANDBY/ON
TURNING OFF THE POWER
STANDBY/O
N
INPUT
KEYSTONE
RESET
L
A
N
P
T
E
N
P
PO
W
E
R
STANDBY/ON INPUT KEYSTONE RESET
LANP
TENP
POWER
Control panel
STANDBY/ON
INPUT
KEYSTONE
RESET
LAN
P
TENP
PO
W
ER
2
Press the STANDBY/ON button again
(control panel or remote control)
Press the STANDBY/ON button again while the "Power off?"
message is visible. The projector lamp goes off and starts cooling
down. The POWER indicator blinks orange while the lamp cools
down. (Pressing the STANDBY/ON button while the POWER
indicator is blinking orange has no effect.)
The system goes into the STANDBY mode after cooling
down and the POWER indicator stops blinking orange and
then lights to solid orange.
STANDBY/ON
power switch
POWER indicator
KEYSTONE
RESET
LANP
TENP
POWER
Except in
emergencies, follow
the above-
mentioned
procedure for
turning power off.
NOTE