Filter
Top Products
1-15
OOPPEERRAATTIIOONNSS ((ccoonnttiinnuueedd))
ENGLISH
No Signal Menu
The same adjustments and settings are available as with the Image and
Options menus when the MENUO button is pressed during display of the
‘NO INPUT IS DETECTED ON ***’ or ‘SYNC IS OUT OF RANGE
ON ***’ message while no signal is received. See Table 1.7 below.
Table 1.7 No Signal Menu
VOLUME
KEYSTONE
BLANK
MIRROR
START UP
MENU COLOR
TIMER
LANGUAGE
AUTO OFF
SYNC ON G
40
+1
Item Description
VOLUME
Volume adjustment: Reduce VOLUME ↔ Increase VOLUME
KEYSTONE
Adjustment:
Reduce size of bottom of image
↔ Reduce size of top of image
BLANK
Select blank screen color: Select color with the and buttons.
*
The image is cleared when the BLANK MODE is set with BLANK ON,
or when there is no signal, and the entire screen is displayed in the
selected color. Note that if
TURN OFF
is selected on the
START UP
the blank screen is displayed in blue when there is no signal.
MIRROR
Operation start/stop: Press the or button.
Select Mirror status: Select mirror status with and buttons.
START UP
Operation start/stop: Press the or button.
Setup initial screen display: Select TURN ON with the button.
Clear initial screen display: Select TURN OFF with the button.
* Note that if TURN OFF is selected the blank screen is displayed in
blue when there is no signal.
MENU COLOR
Select menu background color: Select with the and buttons.
TIMER
Operation start/stop: Press the or button.
Setup initial timer value: Set 1~99 minutes with the and buttons.
LANGUAGE
Operation start/stop: Press the or button.
Select menu display language: Select with the and buttons.
AUTO OFF
Operation start/stop: Press the or button.
Set AUTO OFF: Set 0~99 minutes with the and buttons.
The system automatically enters the standby mode when a signal is
not received for the set time.
Clear AUTO OFF: Select STOP (0 min.) with the button.
Wind Stop is selected the system does not enter the standby mode
even if no signal is received.
SYNC ON G
Operation start/stop: Press the or button.
SYNC ON G valid: Select TURN ON with the button.
SYNC ON G invalid: Select TURN OFF with the button.
* When SYNC ON G is effective, it may not be displayed normally by an input
signal. Remove a signal connector, and make it condition without a signal, and
input a signal again in this case SYNC ON G after it is overridden.