Filter
Top Products
31
ENGLISH
Replace the lamp with new one and
fix it using the same two screws.
• Firmly tighten the lamp screws. Loose screws may cause
bad connection of the connector which in turn may result
in malfunctioning.
4
Screw
Lamp
Install the lamp cover and fix it using screws.
• To prevent burn, install the lamp cover and secure it using the screws.
• Do not turn on the power with lamp cover removed.
5
Lamp (continued)
If you have replaced the lamp after the lamp replacement time had expired, perform the procedure
explained below within 10 minutes after the power is turned on. The power will turn off automatically
when the 10-minute period expires.
2. Reset the lamp time
3
1
2
STANDBY/ON MUTE
POSITION ON
OFF
FREEZE
LASER
RESET
MOUSE ON
BLANK TIMER
RGB VIDEO
INPUT
MENU ON
RIGHT
VOLUME
MAGNIFY
3
1, 2
1) Press the RESET button on projector for 3 seconds or remote control TIMER
button for 3 seconds and display the total lamp used time.
• When accumulated operation time of the lamp reaches 1500 hours, the
following display will appear at the bottom of the screen.
2) Press the RESET button on projector or remote control MENU ON button
during displaying the lamp used time.
3) Select the “0” on the screen using the MENU ( ) button or DISK PAD.
LAMP 1500 0 CANCEL
LAMP 1500 h
←
• Whenever the lamp is replaced, reset the total operation time of the lamp. Do not reset if the lamp has not
been replaced.
• Do not perform resetting without changing the lamp, as this can cause lamp breakage.
Lamp cover
Screw
RESET
MENU
MUTE
INPUT
STANDBY/ON