Filter
Top Products
ENGLISH-9
ENGLISH
ENGLISH-9
OPERATIONS
OPERATIONS
Power ON
1. Check that the power cord is connected correctly.
2.
Set the power switch to [ | ]. The standby mode is selected, and the STANDBY/ON indicator is turned to orange.
3. Press the STANDBY/ON button on the control panel or the remote control transmitter. Warm-up
begins and the STANDBY/ON indicator blinks in green.
4.
The STANDBY/ON indicator ceases blinking and turns to green when power is on. Remove the lens cap.
5. Adjust picture size using the Zoom Knob.
6. Adjust focus using the Focus Ring .
Power OFF
1.
Press the STANDBY/ON button on the control panel or the remote controller. Then,the message
"Power off?" will appear on the screen, and the message will disappear by any operation or no operation for
5 seconds. During this message indication, press the STANDBY/ON button again. The projector lamp
is extinguished and lamp cooling begins. The STANDBY/ON indicator blinks orange during lamp cooling.
Pressing the STANDBY/ON button has no effect while the STANDBY/ON indicator is blinking.
2.
The system assumes the Standby mode when cooling is complete, and the STANDBY/ON indicator ceases
blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].
3. The STANDBY/ON indicator is extinguished when power is off. Attach the lens cap.
Put the Lens cap to the lens properly. In order to do it, keep pushing two knobs on the lens cap, then fit
it to the lens holding the cap in horizontal position.
Power Switch
Lens cap
STANDBY/ON
LASER
BLANK
RGB
VIDEO
AUTO
MENU
MENU SELECT
KEYSTONE
RESET
FREEZE
PinP
MAGNIFY
POSITION
OFF
VOLUME
MUTE
STANDBY/
ON Button
•
Except in emergencies, follow the above-mentioned procedure for turning power off. If the
projector is used improperly, it may very difficult to turn off the projector caused by heating inside the
unit. And the reduction of life time of lamp and LCD panels will be caused by incorrect procedure.
• To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF.
Providing a RS-232C cable is connected, turn on the computer before the projector.
• When a projector continues projecting the same image, the image may remain as an afterimage. Please
do not project the image same for a long time.
NOTE
WARNING • Please read this manual, and the separate “SAFETY
INSTRUCTIONS” thoroughly before using the equipment. Always ensure that
the equipment is used safely.
STANDBY/ON Button
(STANDBY/ON Indicator)
Zoom Knob
Focus Ring