Filter
Top Products
5
LBe careful in handling the power cord.
•
Do not scratch, damage or process the power
cord. Do not bend it forcibly. Also do not put a
heavy object on it, do not heat it and do not pull
it. If you do, the power cord may be damaged
and it may cause a fire, electric shock, etc.
•Do not pull the cord.
•Do not put a heavy object on it.
•Do not damage the cord.
•Do not put it near a heating device.
•
Be careful that this unit is not placed on the
power cord. The power cord may be damaged
and it may cause a fire, electric shock, etc. If
the cord is covered with a carpet, etc. a heavy
object may be put on it without your realizing it.
•
If the cord is damaged (core wire is
exposed, disconnected, etc.), ask
your dealer to replace it. It may
cause a fire, electric shock, etc.
•
Check that no dirt adheres to the power plug and
fully insert without any play. If dirt adheres or
the connection is incomplete, it may cause a fire,
electric shock, etc.
•
The outer shield of power cord must
be connected to ground.
If you do not, it may cause a
electric shock.
LDo not stare directly into the laser
aperture.
•
The laser pointer on the remote
control unit radiates the laser beam
from the laser aperture.
•
Do not stare into the laser aperture or radiate the
laser beam to other persons as the laser emitted
is a class II laser and it could damage you
vision, etc.
Especially pay attention if children are present.
Warning
•
The three labels below are caution labels for the
laser beam.
AVOIDE EXPOSURE–LASER
RADIATION IS EMITTED
FROM THIS APERTURE
CAUTION
LASER RADIATION-
DO NOT STARE INTO BEAM
RADIAZIONI LASER
NON GUARDARE NEL RAGGIO LUCE
APPARECCHIO LASER DI CLASSE 2
RAYONNEMENT LASER
NE PAS REGARDER DANS
LE FAISCEAU APPAREIL
A LASER DE CLASSE 2
LASER-STRAHLUNG
NICHT IN DEN STRAHL
BLICKEN LASER KLASSE2
WAVE LENGTH:670nm
MAX. OUTPUT:1mW
CLASS II LASER PRODUCT
MANUFACTURED
August-97
MANUFACTURER:A
MADE IN JAPAN
LASER APERTURE
Downloaded from www.Manualslib.com manuals search engine