Filter
Top Products
2-4
Usage
English
StarBoard
F
X
-77/F
X
-63/F
X
-82
W
2.2 How to Use StarBoard in Projection Mode
2.2.1 Wired Connection
(1) Connect devices following the page 1-10.
(2) Power up the projector.
(3) Power up PC to start up Windows.
(4) Adjust the position of the projector so that the Windows screen projected by the
projector is within the pen input active area (see page 1-3).
(5) Install and launch the StarBoard Software.
If the board is not detected by the StarBoard Software, check whether the StarBoard
power is on, and whether StarBoard and the PC are properly connected to each
other.
You can perform the board detection using the StarBoard Software. Refer to the
StarBoard Software User’s Guide for details.
(6) Refer to the StarBoard Software User’s Guide for information on using
the StarBoard.
If the cursor location of the PC is different from the pen tip, launch the calibration
programme. Please refer to the StarBoard Software User Guide for details.
Select [Start] → [Programs] → [StarBoard Software] → [ StarBoard Software], or
double-click the StarBoard Software icon on the desktop. (A StarBoard Software icon
will not be created on the desktop unless [Desktop] is checked in the shortcut creation
step during the software installation process.)
Starting StarBoard Software manually