Filter
Top Products
5.3 Configuring the NIC
5-5
AppleTalk Configuration
Chapter 5
5.3.3 Protocol Setup
Use the Protocol Setup option to configure network protocols other
than AppleTalk. Selecting the Protocol Setup function displays the
following screen:
Note
1. Click the protocols to On if you want them to be active. Click
those protocols that you do not want to use to
Off. The utility will
not let you make active any protocol that the NIC does not support
or cannot handle because of active protocol limitations.
2. Type the IP address and subnet mask if you have enabled TCP/IP.
Type the default gateway address, if you have one.
3. Click on
OK when you have finished using this screen.
4. You must power the printer off and on to make the changes take
effect.
5.3.4 Options
Click on Status Sheets: Enable to send a status report to the printer
each time you power it on, or click on
Disable to disable this option.
Click on
OK. The change takes effect the next time you power on the
printer.
• The default values for the IP address and Subnet Mask are shown as
zeros. However, this represents a “no IP address” condition, not an IP
address.