Filter
Top Products
Quantum System
Quick-Start Guide - Operator
6
8.
Replace the Take-Up Key onto the Take-Up Spool,
making sure that it is on the outside of the Leader.
9.
Turn the Take-Up Spool counterclockwise until the edge
of the first label is even with the Peel Bar.
10.
Replace the Label Cassette.
Cleaning & Sanitizing
♦
Proper cleaning prolongs the life and productivity of the machine. Improper cleaning and sanitation will
adversely effect performance of the equipment.
♦
This machine should be cleaned routinely during the day and thoroughly cleaned at the end of the day.
If the system is not cleaned daily, it will not run consistently and will cause service problems.
♦
Refer to the following Cleaning and Sanitizing guidelines.
Do Don’t
DO cover the complete system during cleanup and
hosedown of surrounding areas. Remove cover after
hosedown to prevent condensation in the machine.
DON’T dampen labels, electronic parts or connections.
DON’T use steam or a pressure (water) hose to clean the
system.
DO use mild soap and water solution to clean the
exterior of the Quantum (Palmolive Green or Ivory is
recommended).
DON’T allow water to enter the openings in the housing.
DON’T use a hose or pour water in any area.
DO apply EPA-registered sanitizer according to label
directions to disinfect surfaces.
DON’T exceed EPA and registered recommended
concentrations for detergent or sanitizer.
DON’T operate and/or store the system in an environment
with relative humidity levels consistently in excess of 70%.
DON’T use:
•
Chloride-based cleaners
•
Formula 409
•
Glass cleaners (e.g., Scotty’s Glass Cleaner)
•
Citrus-based cleaners (e.g., Citro-Sol or Bio-T)
•
Caustic cleaners with high pH (e.g., Butchers Block,
concentrated Lysol or Pinesol)