Filter
Top Products
12 0804
english
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Check that the door switch is working properly:
Warning!
If the following procedure cannot be
performed, switch off the document
shredder, disconnect the mains plug
and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and open the front
door while the paper is being drawn in.
The cutting unit must turn off immediately
and the “door open” indicator must light up.
• Close the door.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening. The
light barrier must be clear.
• Switch off the machine and then switch back
on.
The cutting unit starts when paper is fed in.
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer (Cross cut only):
• Spray special cutting block oil through paper
feed opening across the whole width of the
cutting system blades.
• Let the cutting unit run without paper in brief
mode.
Paper dust and particles are shaken off.
Note:
Oiling the cutting unit also improves the cutting
performance of devices with strip cut.
6 Cleaning and maintenance
• Document shredder, ready for connection,
packed in a carton
• 5 waste bags
• 1 CD bag for machines with cutting widths
3.9 and 5.8 mm
• 1 bottle of special cutting apparatus oil
(50 ml) for devices with particle cut
• Operating instructions
Accessories:
• Waste bag, order no. 1.330.995.000
• Special cutting apparatus oil (250 ml)
order no. 1.235.997.403
7 Scope of delivery