Filter
Top Products
standards. Records maintained by Hypertec continue to reflect that units being produced
under this Declaration of Conformity, within the variation that can be expected due to
quantity production and tested on a statistical basis, continue to comply with the applicable
technical standards.
The CardBus Modem 56k Card complies with Part 68 of the FCC rules.
FCC rules permit this device to be directly connected to the telephone network,
using a standardised jack.
Do not use this equipment on a party line or coin line.
Malfunctioning equipment may damage the telephone network. If this device is
not functioning properly, disconnect it until the problem has been determined and
the device has been repaired. Otherwise, the telephone
company may temporarily disconnect service.
CardBus 56k Modem repair can only be performed by Hypertec. It is the
responsibility of the user to report the need for any service of the device to
Hypertec or to one of our authorised agents.
If you encounter any problems with your telephone after installing any new
device, disconnect it from the telephone line to see if the device is the source of
the problem.
The telephone company may change its technical operations and procedures. If
such changes affect the compatibility or use of the device, the telephone company
is required to provide adequate notice of the changes.
European Community (EC) Electromagnetic Compatibility
Directive.
This equipment has been tested and found to comply with the protections requirements of
European Emission Standard EN55022 and the Generic European Immunity Standard
EN50082-1. This equipment is designed to operate in a domestic environment and as such
is tested to the EN55022 ITE domestic emissions limit. The domestic immunity standard
EN50082-1 calls for the following basic standards:
(a) IEC 801-2 Electrostatic Discharge
(b) IEC 801-3 RF Immunity
(c) IEC 801-4 Transient Burst