IBM 2254 Computer Hardware User Manual


 
Installing a drive
To install an internal drive, follow these steps.
1. Remove the cover. See Removing the cover - microtower modelon page 44.
Note: If your computer has a CD drive or DVD drive, you might need to
remove the signal and power cables from the drive.
2. Remove the bay panel from the drive bay by inserting a flat-blade screwdriver
at the end and gently prying it loose.
3. Remove the metal shield from the drive bay by inserting a flat-blade
screwdriver into one of the slots and gently prying it loose.
4. Make sure the drive that you are installing is set correctly as either a master or
a slave device.
v If it is the first CD drive or DVD drive, set as a master device.
v If it is an additional CD drive or DVD drive, set as a slave device.
v If it is a hard disk drive, set as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
Chapter 4. Installing Options 53