Filter
Top Products
23
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
2. Place the monitor panel-side down on a stable, padded, flat work
surface.
3. Remove the four mounting plate retaining screws. One screw at each
corner. Lift the base up and away from the monitor.
Attaching the stand and cables
1. Turn off the monitor and unplug it from the electrical outlet.
2. Place the monitor panel-side down on a stable, padded, flat work
surface
3. Align the screw holes on the swivel base with the corresponding holes
on the back of the monitor.
4. Insert and loosely secure the four screws on the base. Tighten the
screws in an alternating pattern and make sure not to over-tighten.
To obtain the correct cables and/or to get further instructions on installing
them, call the IBM HELPCENTER at the above numbers or contact your
dealer, retailer, or other IBM authorized Servicer.
T50_setup.fm Page 23 Thursday, August 9, 2001 11:09 AM