IBM 42S Personal Computer User Manual


 
NetBAY Power Distribution Units 145
2. Verify that the circuit breaker switch is in the Off position before installing
your Rack PDU.
3. Install the horizontal mounting bracket
3 on one side of the Rack PDU 5 with
M3x5 screws
4 .
Note: There are two sets of mounting holes on the bracket. You can align the
Rack PDU to be even with the back of the rack cabinet or recessed inside,
depending on how you install the bracket.
Figure 61. Installing the mounting brackets for a single device
4. Install the single-device attachment bracket
1 on the other side of the Rack PDU
5 with two M3x5 screws 2 . Make sure that you use the same set of mounting
holes on this bracket as you used on the bracket in the previous step.
5. Determine the U level within your rack cabinet where you are going to install the
Rack PDU; then, install the Flat Panel Monitor Rack Mount Kit and bracket
assembly
2 in the rear of the rack cabinet with four M6 screws and clip nuts or
cage nuts (two screws and nuts per bracket).
Figure 62. Installing the Rack PDU and the blank filler panel
7