IBM 8185 Laptop User Manual


 
3.
Locate
the
Clear
CMOS/Recovery
jumper
on
the
system
board.
See
“Identifying
parts
on
the
system
board”
on
page
83.
4.
If
necessary,
see
“Installing
adapters”
on
page
85
to
remove
any
adapters
that
impede
access
to
the
Clear
CMOS/Recovery
jumper.
5.
Move
the
jumper
from
the
standard
position
(pins
1
and
2)
to
the
maintenance
or
configure
position
(pins
2
and
3).
6.
Replace
the
cover
and
connect
the
power
cord.
See
“Replacing
the
cover
and
connecting
the
cables.”
7.
Restart
the
computer,
leave
it
on
for
approximately
10
seconds.
Turn
off
the
computer
by
holding
the
power
switch
for
approximately
5
seconds.
The
computer
will
turn
off.
8.
Repeat
steps
2
through
4
on
page
95.
9.
Move
the
jumper
back
to
the
standard
(pins
1
and
2).
10.
Replace
the
cover
and
connect
the
power
cord.
See
“Replacing
the
cover
and
connecting
the
cables.”
Replacing
the
cover
and
connecting
the
cables
After
working
with
options,
you
need
to
install
any
removed
parts,
replace
the
cover,
and
reconnect
any
cables,
including
telephone
lines
and
power
cords.
Also,
depending
on
the
option
that
is
installed,
you
might
need
to
confirm
the
updated
information
in
the
IBM
Setup
Utility
program.
To
replace
the
cover
and
connect
cables
to
your
computer:
1.
Ensure
that
all
components
have
been
reassembled
correctly
and
that
no
tools
or
loose
screws
are
left
inside
your
computer.
2.
Clear
any
cables
that
might
impede
the
replacement
of
the
cover.
3.
Position
the
cover
on
the
chassis
so
that
the
rail
guides
on
the
bottom
of
the
cover
engage
the
rails
and
push
the
cover
closed
until
it
latches.
4.
Reconnect
the
external
cables
and
power
cords
to
the
computer.
See
“Installing
external
options”
on
page
78.
96
User
Guide