Filter
Top Products
8
COMPUTERTOP TV-III
2.Setup and installation of the
Computertop TV-III software
must be done at the DOS
command level. Before
attempting to install the
Computertop TV-III software,
you must exit Microsoft
Windows. Do not exit Microsoft
Windows by using the DOS icon.
3.Insert the Computertop TV-III
setup disk in drive A:.
4.Type A:<CR>. A DOS prompt
with drive letter A should be
visible.
5.Type SETUP <CR> and follow
the instructions.
6.Once software installation is
complete, you can start
Computertop TV-III operation
by double-clicking on the
Computertop TV-III icon. The
cursor will change to an
“hourglass” while the board is
being initialized. When the
cursor returns to normal, hit the
SHIFT key, release it, then hit
the CONTROL key and release
it. In a few seconds, the
Computertop TV-III video
window will pop up.