Filter
Top Products
16
Manual Setup
Normally, you can complete the setup procedure using AUTO SETUP; however,
if your screen image is still distorted after you perform
AUTO SETUP or the
Installation CD does not run on your system, perform MANUAL SETUP.
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2.
Display the image you most frequently use on the screen then go to
windows shut down mode.
3. Press the OSD Enter button at the bottom of the monitor to display
the initial OSD menu.
4. Use the or button to select the Image Setup icon and press
the OSD Enter button to access.
5.
6.
You have completed monitor setup.
Use the or button to select Clock and Phase to adjustment.
(a) "Clock" (pixel frequency) controls the number of pixels scanned
by one horizontal sweep.
If the frequency is not correct, the screen shows vertical stripes
and the picture does not have the correct width.
(b) "Phase" adjust the phase of the pixel clock signal. With a wrong
phase adjustment the picture has horizontal disturbances in
light picture.
Use a select ( or ) button to manually adjust to correct and execute
save go to up menu then press the Exit ( ) button to leave OSD menu.
Manual setup is not required when using digital input.