IBM MT2679 Laptop User Manual


 
Symptom or error FRU or action, in sequence
0185
Bad
startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
1. Run BIOS Setup Utility.
Press F9, and Enter to
load the default setting.
Then save the current
setting by pressing F10.
0187
EAIA
data access error—The
access to EEPROM is failed.
System board.
0188
Invalid
RFID Serialization
Information Area.
System board.
0189
Invalid
RFID configuration
information area—The
EEPROM checksum is not
correct.
System board.
0190
Critical
low-battery error
1. Charge the battery pack.
2. Battery pack.
0191
System
Security—Invalid
Remote Change requested.
1. Run BIOS Setup Utility,
and then save current
setting by pressing F10.
2. System board.
0192
System
Security— IBM
Embedded Security hardware
tamper detected.
System board.
0199
System
Security—IBM Security
password retry count exceeded.
1. Run BIOS Setup Utility,
and then save the current
setting by pressing F10.
2. System board.
01C8
Two
or more modem devices
are found. Remove all but one
of them. Press <Esc> to
continue.
1. Remove either a Mini-PCI
Card or a modem
daughter card. Otherwise,
press Esc to ignore the
warning message.
2. System board.
01C9
More
than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
0200
Hard
disk error—The hard disk
is not working.
1. Reseat the hard disk
drive.
2. Load Setup Defaults in
BIOS Setup Utility.
3. Hard disk drive.
4. System board.
021x
Keyboard
error.
Run interactive tests of the
keyboard and the auxiliary
input device.
Symptom-to-FRU index
ThinkPad T43/T43p Series 59