Filter
Top Products
PANEL1173-841 User’s Manual
Phoenix-Award BIOS Utility
49
to restore the system when a “wake up” event occurs.
z Run VGABIOS if S3 Resume
When this item is set Auto, the system will run VGA BIOS if it is
reaumed from the S3 state.
z Power Management
This option allows you to select the type (or degree) of power
saving for Doze, Standby, and Suspend modes. The table below
describes each power management mode:
Max Saving
It is maximum power savings, only available for SL
CPUs. The inactivity period is 1 minute in each mode.
User Define
It sets each mode. Select time-out periods in the PM
Timers section.
Min Saving
It is minimum power savings. The inactivity period is 1
hour in each mode (except the hard drive).
Disabled
Default value
z Video Off Method
This setting determines the manner in which the monitor is blanked.
V/H
SYNC+Blank
Turns OFF vertical and horizontal
synchronization ports and writes blanks to the
video buffer
DPMS
Select this option if your monitor supports the
Display Power Management Signaling (DPMS)
standard of the Video Electronics Standards
Association (VESA). Use the software supplied
for your video subsystem to select video power
management values.
Blank Screen
System only writes blanks to the video buffer.
z Video Off In Suspend
This item defines if the video is powered down when the system is
put into suspend mode.
z Suspend Type
If this item is set to the default Stop Grant, the CPU will go into Idle
Mode during power saving mode.
z Moden Use IRQ
If you want an incoming call on a modem to automatically resume
the system from a powersaving mode, use this item to specify the
interrupt request line (IRQ) used by the modem. You might have to