Filter
Top Products
Chapter 2. Architecture and technical overview 13
EC Level....................H10826
Serial Number...............0000000026
FRU Number..................09P3666
Manufacture ID..............1980
Version.....................RS6K
Product Specific.(ZC).......PS=00165A0BC0,LB=000EE6B280,
SB=00059682F0,NP=01,L2=04096,
PF=754,SV=3,VR=1,ER=00
Physical Location: P1-C1
For example, PS shows the processor speed in hex-number digit as follows:
a. (0x00165A0BC0 = 375000000 Hz = 375 MHz).
b. (0x001AD27480 = 450000000 Hz = 450 MHz).
4. Use the lscfg -vp | more command. Page down to the Processor Card entry and search
for the PF entry under the Product Specification (ZC) section. If you see PF=754, then
you have a 375 MHz card (L2 = 4 MB); if you see PF=758, then you have a 450 MHz card
(L2 = 8 MB).
2.1.6 Processor part numbers
Due to manufacturing improvements, the part number of the processor cards might change.
You can determine the part number of the current installed processor cards using the
following method:
1. Enter the AIX command: lscfg -vp | more
2. Page down to the Processor Card entry and search for the Product Specification (ZC)
entry.
3. Determine the appropriate part number.
2.2 Memory
The memory subsystem of the Models 6C1 and 6E1 support a 128 bit data path to memory
along with an 8-bit ECC code that provides single bit correction, double bit error detection,
and 4-bit packet error detection. A minimum of 512 MB of memory is required, and can be
expanded to a maximum of 8 GB SDRAM.
Figure 2-2 Memory card
Dual inline memory modules (DIMMs) must be ordered and installed in matched (size and
speed) pairs on the memory card. They are available in two sizes: 256 MB and 512 MB. The
memory card can accommodate eight pairs of DIMM sockets.
The supported method to install DIMMs is to start at the bottom of each card (card slot J1 and
J2) and then move up.
The system design gives you the flexibility to mix 256 MB and 512 MB SDRAM DIMM
features on the Memory Expansion Kit without affecting performance.