Filter
Top Products
(B) If SVP is not installed
1. Turn off the computer.
2. Remove the DIMM cover from the bottom of the
computer.
3. Remove the backup battery. For information on how to
remove the backup battery, see “1030 Backup battery”
on page 60
4. Turn on the computer and wait until the POST ends.
After the POST ends, the password prompt does not
appear. The POP has been removed.
5. Reinstall the backup battery and the DIMM cover.
How to remove the hard-disk password:
Attention:
If User only mode is selected and the user HDP is
forgotten and cannot be made available to the servicer,
IBM does not provide any services to reset the user HDPs
nor recover data from the hard-disk drive. The hard-disk
drive can be replaced for a scheduled fee.
To remove the user HDP that has been forgotten, when
the SVP and master HDP is known,do the following:
1. Power on the computer by pressing and holding F1.
2. Enter the SVP. The IBM BIOS Setup Utility menu
appears.
3. Select Password, using the cursor keys to move down
the menu.
4. Select Hard-disk x password, where x is the letter of
the hard-disk drive. A pop-up window opens.
5. Select either User HDP or Master HDP.
6. Enter the master HDP; then leave the New Password
field blank and press Enter twice.
7. Press F10
8. Select Yes in the Setup Configuration window. Both
user HDP and master HDP will have been removed.
Power management
To reduce power consumption, the computer has three
power management modes: screen blank, standby, and
hibernation.
Screen blank mode: In screen blank mode, the following
occurs:
v The LCD backlight turns off.
v The hard disk drive motor stops.
v The speaker is muted.
28 ThinkPad X20, X21, X22, X23, X24